Taylor Certified Pre-Owned Equipment
100% Guaranteed Satification Searching for good used equipment is a difficult task. We reject many pieces of equipment that are offered to us to re-purchase due to age and
just as importantly how the equipment was maintained. Taylor equipment is known for it’s quality and longevity but as in anything else how it is treated can greatly affect it’s
reliability. There are many used Taylor’s being offered in the market place that are past their life and should not be resold. We can offer assistance if you are looking at Taylor
equipment in the field to make sure you are getting what is being presented. The adage “you get what you pay for” and “if it sounds to good to be true" usually is the case for low price
equipment being sold in the market place.
Our guarantee is any equipment that we offer will go through a complete diagnostic testing and is Taylor certified to be quality equipment with full warranties that you can count on to build
your business. Please call our sales department for our inventory of Taylor Certified Pre-owned equipment available.
Our Warranty Our Pre-owned equipment includes a one year parts and labor warranty. Warranty includes delivery, installation, start-up
and staff training.
38 Point Diagnostic Testing Process of All Machine Functions
- Replace rear shell bearing(s)
- Install new Tune-up Kit
- Replace all scraper blades
- Steam clean machine
- Spray paint interior
- Clean condensers
- Check compressor amperage draws
- Check pulley alignment
- Check and/or replace belts
- Check amperage draw of beater motor(s)
- Tighten all electrical connections
- Clean contacts on line starters
- Check hopper refrigeration system
- Adjust E.P.R. valve
- Set expansion valves
- Check refrigerant
- Check initial freeze down time
- Clean or replace casters
- Check pump operation
- Check or replace pump parts
- Check feed tube/ air orifice
- Check condenser fan operation
- Align drive couplings
- Check beater motor overloads
- Adjust draw switches
- Check beater assemblies
- Check water valve operation
- Check for water leaks
- Record head pressures
- Replace dented panels
- Install new cord(s) if necessary
- Check cycle times
- Replace hopper gasket
- Set freezing cylinder (temp)
- Set hopper temperatures
- Set -'stand-by" temperatures
- Check mix indicator lights
- Check gear motor/drive shaft alignment